
Chapter7. Appendix
def port 1 flow
[none/xon/rts]
Set the flow control scheme.
def port 1 signal
[data/modem]
Set the signal line checking method for the device to be
connected to the given serial port.
def port 1 remote
<IP address>
When the Operation Mode is set to TCP Client or UDP Client,
set the IP address to connect to.
def port 1 remoteport
<socket number>
When the Operation Mode is set to TCP Client or UDP Client,
set the socket number to connect to.
def port 1 keepalive
<0 ~ 65535>
After a certain amount of time passes without any
communication after the socket connection between the given
serial port and the server is established, automatically
disconnect the socket connection.
def port 1 latency
<msec>
This needs to be set when consecutive data from the given
serial port needs to be transmitted to socket at once.
def port 1 login
[Enable / Disable]
When the Operation Mode is set to TCP Server, ask for the
username and password when the client tries to connect. Set
to 1 to enable.
def port 1 loginname
<username>
When the Operation Mode is set to TCP Server, set the
username to ask for(Max 8 bytes)
def port 1 loginpass
<password>
When the Operation Mode is set as TCP Server, set the
password to ask for( Max 8 bytes)
6.6 Username/Password Commands
Configure username and password for Web/Telnet/FTP.
Set username to use in Web, Telnet, or FTP.
16 Characters at maximum.
Set password to use in Web, Telnet, or FTP.
16 Characters at maximum.
6.7 System Commands
Restore all settings to factory default. Requires reboot for changes to
take effect.
Save current configuration settings. Requires reboot for changes to take
effect.
Comentarios a estos manuales